1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
|
//! # Overclocking the RP2350 to 200 MHz
//!
//! This example demonstrates how to configure the RP2350 to run at 200 MHz instead of the default 150 MHz.
//!
//! ## Note
//!
//! As of yet there is no official support for running the RP235x at higher clock frequencies and/or other core voltages than the default.
//! Doing so may cause unexpected behavior and/or damage the chip.
#![no_std]
#![no_main]
use defmt::*;
use embassy_executor::Spawner;
use embassy_rp::clocks::{clk_sys_freq, core_voltage, ClockConfig, CoreVoltage};
use embassy_rp::config::Config;
use embassy_rp::gpio::{Level, Output};
use embassy_time::{Duration, Instant, Timer};
use {defmt_rtt as _, panic_probe as _};
const COUNT_TO: i64 = 10_000_000;
#[embassy_executor::main]
async fn main(_spawner: Spawner) -> ! {
// Set up for clock frequency of 200 MHz, setting all necessary defaults.
let mut config = Config::new(ClockConfig::system_freq(200_000_000).unwrap());
// since for the rp235x there is no official support for higher clock frequencies, `system_freq()` will not set a voltage for us.
// We need to guess the core voltage, that is needed for the higher clock frequency. Going with a small increase from the default 1.1V here, based on
// what we know about the RP2040. This is not guaranteed to be correct.
config.clocks.core_voltage = CoreVoltage::V1_15;
// Initialize the peripherals
let p = embassy_rp::init(config);
// Show CPU frequency for verification
let sys_freq = clk_sys_freq();
info!("System clock frequency: {} MHz", sys_freq / 1_000_000);
// Show core voltage for verification
let core_voltage = core_voltage().unwrap();
info!("Core voltage: {}", core_voltage);
// LED to indicate the system is running
let mut led = Output::new(p.PIN_25, Level::Low);
loop {
// Reset the counter at the start of measurement period
let mut counter = 0;
// Turn LED on while counting
led.set_high();
let start = Instant::now();
// This is a busy loop that will take some time to complete
while counter < COUNT_TO {
counter += 1;
}
let elapsed = Instant::now() - start;
// Report the elapsed time
led.set_low();
info!(
"At {}Mhz: Elapsed time to count to {}: {}ms",
sys_freq / 1_000_000,
counter,
elapsed.as_millis()
);
// Wait 2 seconds before starting the next measurement
Timer::after(Duration::from_secs(2)).await;
}
}
|
